 Friends links |
|
| Picture |
Heading |
Updated |
 |
VENZO 680 Shock Test System
VENZO 680 Shock Test System Features · Capture transient signals with specified trigger level, slop and position · 100Mbps Ethernet port connection · Capture Duration: 1ms-10,000ms · Pulse Duration: 0.05ms to 5,000ms · Maximum sampling rate up to 204.8 kH |
2017-11-29 |
 |
VESSTA 9EX MIMO Vibration Controller
Based on the impedance matrix compensation decoupling control, it can accurately control the coherence and the phase between the reference spectrums, achieve online control error correction, to adapt the system characteristics nonlinear |
2017-11-21 |
 |
Force Sensors
Force Sensor is defined as a transducer that converts an input mechanical force into an electrical output signal. Force Sensors are also commonly known as Force Transducers, which can be easily integrated into force measurement applications These series o |
2017-11-21 |
 |
VENZO 820 Vibration Controller
Rear Panel: connectors include 2/8 Analog Input Channels, a Drive Channel, a100 BASE-T Network Port, an AUX channel (only for VENZO 880, can be adjusted to 2-axis drive control channel), a grounding-end, an External Emergency Abort Jack and a terminal blo |
2017-11-21 |
 |
8210 Transducer Calibration System
8210 system is suitable for voltage, charge, IEPE and TEDS types vibration transducer calibration. Adopt back-to-back comparison method (ISO 16063-21:2003) to complete acceleration transducer (or velocity transducer or vibration meter) calibration, to fas |
2017-11-19 |
 |
VESSTA 4EX MIMO Vibration Controller
VESSTA MIMO Vibration controller is based on PXIe Bus and DSP board Structure, by the combination of different data acquisition card and output interface card, it can realize large-scale-channel distributed data acquisition |
2017-11-05 |
 |
VENZO 880 Vibration Controller
Wave Types: Half-sine, Haversine, Initial and final Peak Saw Tooth, Triangle, Rectangle and Trapezoid.Negative Pulse: Pulses can be in negative directionAveraging: Pulses can be averaged for the control. |
2017-10-16 |
 |
General Purpose Single Axis Accelerometers
Piezoelectric accelerometers, both IEPE and charge mode types, are designed for the applications where the actual acceleration rang is unknown, or where shock and vibration measurements are required. IEPE accelerometers featured integral electronics, and |
2017-10-14 |
|
